Teo 8030X Manuel d'utilisateur télécharger pdf

13-280109 Rev. A

September 2005

The Model 8030X Button Expansion Module adds an additional 30 multifunction keys to a Tone

Commander 8610, 8620, or 8810 ISDN telephone.

The following items are included with each 8030X:

(1) Model 8030X Button Expansion Module

(1) double-width mounting stand

(3) mounting screws for attaching to the telephone

(1) ribbon cable with ferrite filter

(1) key label sheet

(2) key label overlays

(1) Installation Instructions (this manual)

Button Expansion Module Installation

1. Disconnect the line cord.

Power must be disconnected before installing the 8030X.

Wait 10 seconds after disconnecting power before proceeding.

2. Press the telephone stand down to disengage the snap tabs, then lift off the stand.

The low desktop stand position is shown; the removal procedure is the same for high desktop

and wall mount positions.

3. Remove the Phillips screw from the center of the expansion cover. Press the back edge in to

release the retention snap, and tilt the top edge of the cover away from the telephone as shown

to remove the cover.

Your telephone may have an 8001TA, 8002TA, or 8003TA Terminal Adapter installed in place of

the cover.

8030

Button Expansion Module

Installation Instructions

1 2 3 4

13-280109 Rev. ASeptember 2005The Model 8030X Button Expansion Module adds an additional 30 multifunction keys to a ToneCommander 8610, 8620, or 8810

Page 2 Tone Commander 8030X Expansion Module4. Lay the telephone and 8030X face down as shown. Fasten the 8030X to the telephone with theprovided mou

Tone Commander 8030X Expansion Module Page 3High Desktop PositionWall Mount Position8. Label the keys on the 8030X, and insert the labels into the op

Page 4

Page 4 Tone Commander 8030X Expansion ModuleServiceRepair of the 8030X must be done by Tone Commander. Prior to equipment removal, call ToneCommander

Pas de commentaire

Teo 8030X Manuel d'utilisateur